It is a price pfister, single handle pullout faucet (no side sprayer), it seems all of sudden I started losing pressure, particularly on the hot water side. The pressure in the rest of the house is fine. Any ideas why this would happen and how to fix it? I cleaned the aerator but that didn’t do anything.

I have a portable dishwasher and need to hook it up to a faucet that is a one handle with the sprayer attached as part of the spigot like this:

http://www.homedepot.com/Kitchen-Kitchen-Faucets/Price-Pfister/h_d1/N-5yc1vZ1xiyZar0kZ16z/R-100678516/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053

I need to attach a portable dishwasher to this and cannot figure out what type of adapter I need. I heard there is a rubber adapter but cannot find it at Lowe’s or Home Depot. Any advice?

I just purchased and installed a Price Pfister Florentino 2 lever kitchen faucet. When turning off the hot water, the lever rotates beyond the off position and gets out of alignment. I keep having to unscrew the handle, realign it and tighten it back in place. But it quickly get turned around again with normal use. What should I do to fix this permanently??

I have a single handle Price Pfister Parisa model, that has an extendable sprayer. Recently I have lost significant water pressure. Also, when I turn the water off, the water continues to run at low pressure for approximately 2-3 seconds before stopping. At first I thought it may be the areator, but I removed the sprayer, and the same problems persist through the sprayer hose alone. Please help and be specific. I am a first time homeowner and a complete idiot when it comes to plumbing. Thanks in advance!
someone said to put the hose in a bucket. I’ve already removed the sprayer and ran the water through the hose and the problem persists.

Here’s My Kitchen sink model: http://www.pricepfister.com/Support/Faq/50160000000IGXcAAO.aspx
2 weeks ago my kitchen sink started leaking from the top of the handle on the hot water pipe. So, as suggested by Price Pfister, I replaced the cartridge. However, that did not stop the leak. It still leaks from the hot water pipe near the top of the handle. Furthermore, I am having a hard time removing the whole handle due to pipes and disposal in the way. Should I just replace the whole faucet system?

I have a single handle Price Pfister kitchen sink faucet which is wobbly. When I looked under the cabinet it seems as if one of the plastic nuts is not screwed all the way up, but it is frozen where it’s at. I can’t budge it, and I think it might be cross-threaded. Apparently the faucet was installed using some type putty which held it in place, and now all of that has come loose, also. How can I get this nut off, so that I can tighten up the faucet? And might I also mention that it is in a very awkward, hard-to-get-to spot!!